Productsiso technical specification for grinding balls nvns in

BF Flotation Cell

BF flotation cell has two types: type I and type II. Type I is improved as suction cell referring to model SF; type II is improved as direct flow cell referring to model JJF.

more+

Cyclone Unit

Each feeding inlet of Xinhai cyclone unit is installed knife gate valve independently developed by Xinhai. This valve with small dimension reduces the diameter of cyclone unit.

more+

Hydraulic Cone Crusher

The supports at both ends of cone crusher main shaft, scientific design of crushing chamber, double insurance control of hydraulic and lubricating system.

more+

Overflow Type Ball Mill

Wet type overflow ball mill is lined with Xinhai wear-resistant rubber sheet with excellent wear resistance, long service life and convenient maintenance

more+

Grid Type Ball Mill

Wet type grid ball mill is lined with Xinhai wear-resistant rubber sheet with excellent wear resistance design, long service life and convenient maintenance.

more+

Round Vibrating Screen(YA)

Ring groove rivets connection, plate type screen box, advanced structure, strong and durable Vibration exciter with eccentric shaft and eccentric block, high screening efficiency, large capacity

more+

Jaw Crusher

Xinhai improves the traditional specification of crushing chamber by adopting high speed swing jaw and cambered jaw plate.

more+

Hammer Crusher

High-speed hammer impacts materials to crush materials. There are two ways of crushing (Wet and dry)

more+

Jig

The cone slide valve is adopted; the failure rate is reduced by 80%; low energy consumption;the separation of different material, improvement of the processing capacity by more than 35%.

more+

Energy Saving Ball Mill

Cylindrical energy saving grid ball mill is lined grooved ring plate which increases the contact surface of ball and ore and strengthens the grinding.

more+

Cylinder Energy-Saving Overflow Ball Mill

20-30%. Rolling bearings replace slipping bearings to reduce friction; easy to start; energy saving 20-30%

more+

SF Flotation Cell

Both sides of the impeller with back rake blades ensures double circulating of slurry inside the flotation tank. Forward type tank, small dead end, fast foam movement

more+

ISO 3290-1:2014en, Rolling bearings — Balls — Part 1: Steel balls

Each member body interested in a subject for which a technical committee has This part of ISO 3290 specifies requirements for finished steel balls for rolling

more+

ISOTC 29SC 5 - Grinding wheels and abrasives

29SC 5. Grinding wheels and abrasives ISO Technical Programme Manager : Mme Maho IT Tools that help support the standards development process.

more+

ISOTC 29SC 5 - Grinding wheels and abrasives

Standards under development ISO 603-1:1999Cor 1:1999 Bonded abrasive products -- Dimensions -- Part 5: Grinding wheels for surface grindingface

more+

ISO 603-14:1999 - Bonded abrasive products -- Dimensions -- Part

Publications and products Store Standards catalogue Browse by ICS 25 25.100 25.100.70; ISO 603-14:1999. p. 21898. ISO 603-14:1999 Preview. Bonded abrasive products -- Dimensions -- Part 14: Grinding wheels for deburring and fettlingsnagging on an angle grinder Technical Committee. : ISOTC 29SC 5.

more+

ISO 3290-1:2008 - Rolling bearings -- Balls -- Part 1: Steel balls

This standard has been revised by ISO 3290-1:2014. ISO 3290-1:2008 specifies requirements for finished steel balls for rolling bearings. Technical Committee.

more+

PRE Post:gold mining areas in tanzania
NEXT Post:stone crusher manufacturers chennai

1993-2018 Xinhai Machine . All rights reserved | Design by Xinhai